Mother

By Dermot Tynan, almost 12 years ago.

The main computer on board Nostromo in the film Alien was called Mother. It seems only right that we should call our main processor by the same name.

• February 23, 2013
• |
• |

Igor and Otto

By Dermot Tynan, almost 12 years ago.

The Kalopa motor control board was designed as a general-purpose Atmel board with ancillary electronics for a wide variety of purposes. It includes two H-Bridge motor controllers, driven by two 16 bit PWM outputs. You can exchange one of the motor controllers for an 8-channel servo controller, also using one of the PWM outputs. It has a standard RS232 port with an RJ45 connector on the end. There is a MAX232 to convert logic levels to proper RS232 voltages. If you want to use radio control, you can instead populate the board with an R5-434 radio receiver. It will listen for data on 434MHz and feed it to the Atmel. The processor itself is the bog-standard Atmel ATmega8 with 8k of code and about 512 bytes of RAM.

• February 26, 2013
• |
• |

Battery and Solar Design

By Dermot Tynan, almost 12 years ago.

There will be at least two Vcc busses on board. Labeled, oddly enough, as Vcc1 and Vcc2. The difference between them is that Vcc1 is always on, at all times, and Vcc2 (through VccN) are selectable by Igor.

The main processor runs off Vcc2, but Igor (and Otto) both run off Vcc1. In situations where voltage levels are critical, Vcc2 will be switched off and the boat will continue on whatever course had previously been set, until either voltage levels are healthy, the specified "wake-up" time has elapsed, or there are critical issues which require Mother to get involved. A critical situation could be something like a dramatic wind shift, or an error such as a mis-reading from a sensor.

• March 19, 2013
• |
• |

The Software...

By Dermot Tynan, almost 12 years ago.

I've been asked recently, about the software platforms used on board Beoga Beag. This seems as good a time as any, to talk about the various layers. As mentioned previously, the lower layer is a custom board, running an ATmega8 Atmel processor. The software (Igor and Otto) is custom-written in C for the boat.

• March 19, 2013
• |
• |

Sailboat Guidance System

By Dermot Tynan, about 11 years ago.

A quick look at the almost-complete Sailboat Guidance System (SGS). The board on the left is Igor. Otto is on the right, and the main CPU (Mother) is hidden underneath. The ribbon cable brings all the I/O to and from the boards. The red insulating tape is to remind me of some of the last remaining wires which need to be connected. You can also just about make out the DC/DC converter which is just underneath the ribbon cable at the bottom of the picture.

• October 27, 2013
• |
• |